- Important information
- New features
- Known problems
- Program corrections
- User guide corrections
- Miscellaneous
- Release history
Important information
- None.
New features
- None.
Known Problems
- None.
Program Corrections
- None.
User guide corrections
- None.
Miscellaneous
- None.
Release history
V6.21 2011-07-05
Program corrections- None.
- None.
V6.20 2011-04-29
Program corrections- None.
- None.
V6.10 2010-11-04
Program corrections- None.
- None.
V5.50 2010-04-21
Program corrections-
In EWARM 5.50.5:
Starting execution from a breakpoint no longer failes when there is a breakpoint also on the next instruction. This earlier resulted with the error message "Unable to start execution 0x00000004"
[EW21835] -
In EWARM 5.50.6:
Implemented the special reset sequence needed by TI Stellaris Tempest/Firestorm devices.
[EWARM-973]
- None.
V5.41 2009-12-14
Program corrections- None.
- None.
V5.40 2009-07-10
Program corrections- None.
- Supports both SWD and JTAG.
V5.30 2009-01-23
Program corrections-
Data breakpoints could only be used right after first download.
Any subsequent downloads, data breakpoints were disabled and could not be enabled.
[EW20360]
- None.
V5.20 2008-06-24
Program corrections-
For Cortex-M, the hardware breakpoint was not removed when it was cleared.
This happened when there was only one breakpoint set.
[EW20251]
- None.
V5.11 2007-11-28
Program corrections-
For Cortex-M3, sometimes the debugger incorrectly left hardware breakpoints enabled during step which made the target seem to be halted on the current address.
[EW18848]
-
Data breakpoints. For more information refer to
Part 6. C-SPY hardware debugger systems in the EWARM Debugging Guide
V5.10 2007-07-02
- Cortex-M3 was not supported in 5.10.
V4.41A 2006-12-08
New features- Derivatives based on Rev C silicon are supported.
- There is USB driver support for both old and new evaluation boards.
V4.40A 2006-07-07
- First release.